Electromechanical two posts lifts with base

KPS305 - 306

Base with small ramps for easy drive through.

Stabilising feet at the base of the posts.

Lifting height over 2 metres.

Tubular structure made of 5 robot welded sections, nothing sturdier in the world.

Automatic and permanent nut lubrication system to guarantee efficient lubrication during lifting and descent.

Main nut and safety nut made of bronze (no plastic) with high resistance to wear, for greater safety.

Steel high resistance rolled screws, to provide long life.

The carriage driven by 10 low friction slides on the post external part assure equilibrated and steady lifting also in case of asymmetric loading and prevent transmission of flexion to the spindles and the nuts, granting long life.

Automatic arm locking during lifting and automatic unlocking when the arm reaches the floor – self-locking conical design.

Very low pad, adjustable height.

Specially manufactured motors fitted with overheating protection switch.

CE approved lift with low voltage controls.

Arms easy adjustable in length to facilitate asymmetric loading and easy door opening.

KPS305C2 / 2700 kg
KPS306C2 / 3200 kg

Lift with base for easier installation on low quality floors.

Min. pad height of 95 mm only.

Two stage short arms.

Transmission with pretensioned high resistance chain with safety device.

KPS305C3 / 2700 kg
KPS306C3 / 3200 kg

Three stage short arms, being shorter when in closed position to provide asymmetric loading of large vehicles, and longer when fully extended: recommended for off-road vehicles.

KPS306C3K / 3200 kg

Arms suitable for quick drop-in extensions and other lifting accessories.

KPS305HE / 2700 kg
KPS306HE / 3200 kg

Exclusive lift with self supporting base: installation is possible on floor with poor surface anchorage.

Shaft transmission between posts through oil filled conic gear boxes requiring no maintenance.

Three stage short arms provide asymmetric lifting of off -road and large vehicles.

KPS305HER / 2700 kg
KPS306HER / 3200 kg

Very low profile arms, parallel to the floor: double thread pads with a min. height of 80mm only.

Recommended for sport cars and very low profile vehicles.

KPS305HEK / 2700 kg
KPS306HEK / 3200 kg

Arms suitable for quick drop-in extensions and other lifting accessories.